Lucent WaveACCESS LINK BR132, Быстрое руководство по установке

Страница: 55 / 80

Installing the WaveACCESS NET System 2-17
Step 2: Connecting to the Network
This step involves connecting the CU132 to the
network.
To connect the CU132 to the network:
1. Connect one end of a standard 10Base-T RJ-45
Ethernet cable to the hub or router.
2. Insert the opposite end of the cable into the socket
marked ETHERNET on the back panel of the CU132.
The CU132 is now connected to the network.
Step 3: Connecting Several Collocated
CU132s
This step is necessary only if you have a large or
multi-sectored POP with more than one WaveACCESS
NET CU132. This step entails connecting different
CU132 devices together using a standard 10Base-T
(UTP) Ethernet cable. The cable is attached from one of
the two EXT connectors on the back panel of one unit,
to the alternate EXT connector on another unit. By
connecting all the units in this manner, you effectively
"daisy-chain" them. You may use a category 5 Ethernet
cable of up to 100 meters in length.
Note: The EXT sockets are the same as the Ethernet socket.
Take care to ensure the cables for connecting collocated
units are not inserted into the Ethernet socket.