Software Installation Overview
-1
WaveLAN/ISA Card User’s Guide
3
Installing the Software
3
Software Installation
Overview
3
Installing under
Windows 95/NT
3
If you are installing WaveLAN/ISA into a computer running
the Windows 95 or Windows NT operating system, please
refer to the special Installation Bulletins (see “Further
Information”in the “About This Manual” section)..
Note:
The WaveLAN Diagnostic Utilities are MS-DOS based.
If you would like to be able to use the WaveLAN utilities
on a Windows 95/NT computer, the computer must
have MS-DOS installed. To run the utilities, you must
restart the computer in MS-DOS mode (you can not run
the utilities from an MS-DOS box under Windows).
Installing under
MS-DOS
3
The recommended installation procedure to install
WaveLAN/ISA under MS-DOS (or Windows v.3.x) is as
follows:
1
Copy WaveLAN software to the computer's hard
disk.
2
Create a Utilities Diskette.
3
Install the network operating system software on the
computer.
4
Edit the network configuration file to include
WaveLAN-specific configuration parameters.
5
Make a WAVELAN.INI file for use by the WaveLAN
utilities.
6
Reboot the computer to verify that the network
driver loads successfully
7
If necessary, run the Frequency select utility to
change the card's operating frequency.
isa-src.bk : isa-ch3.frm Page 1 Monday, October 14, 1996 1:23 PM
