System Customization
■
PBX/CENTREX LINE ACCESS CODE
Press FEATURE. Dial 5.
All of the line indicator lights will go off.
To ENTER a system-wide PBX/Centrex dial code.
Dial the desired dial code. Press ADD button. You will hear the confirmation tone when the
code is added. If there are already four other codes programmed you will hear the error tone.
The digit 9 is preset as the PBX/Centrex code, so there is room for three other codes. You may,
of course, erase the 9 code if you want.
To ERASE a system-wide PBX/Centrex dial code.
Dial the code you want to erase. Press DROP. You will hear the confirmation tone when the
code is erased. If the code is not there to be erased, you will hear the error tone.
To ERASE all codes.
Press DROP. Dial
✱
. Press DROP. You will hear the confirmation tone if you successfully
followed the DROP procedure.
You may continue to enter or erase codes or you may exit the feature.
■
EXTERNAL ALERT
Press FEATURE. Dial 6.
Each line indicator light will show the current EXTERNAL ALERT status for that line. (Line
assignments are labeled on the system administration overlay and shown in the table on page 15.)
To make changes, press the line button(s) for the line(s) on which you want to make a
particular change and dial one of the digits from the table below. You may press more than
one line button to make the change on more than one line. If you enter a digit without first
pressing a line button you will hear the error tone.
DIAL
INDICATOR LIGHT
SETTING
1
OFF
No Alert
2
ON
Night Only
(installed)
3
Even Flash
Day Only
4
“Wink” (Short ON, Long OFF)
Always On
■
DIAL TYPE
Press FEATURE. Dial 7.
Each line indicator light will show the current DIAL TYPE for that line. (Line assignments are
labeled on the system administration overlay and shown in the table on page 15.) If the
light is OFF, that line is set for Touch Tone dialing. If the light is ON, the line is set for
Dial Pulse
dialing. To change the DIAL TYPE for a line or lines, press the line button(s) and
dial the appropriate digit from the table below. You may press more than one line button to
make the change on more than one line. If you enter a digit without first pressing a line button
you will hear the error tone.
DIAL
INDICATOR LIGHT
SETTING
1
OFF
Touch Tone
2
ON
Dial Pulse
(installed)
Administration Manual 17
