System Customization - 1
If you dialed 1 in STEP 5 on page 13 you began System Customization. The features on the
following pages may be programmed in any order, and you may exit customization at any time,
leaving unchanged features at previously-set values. You may also use System Customization
to check the setting of a feature. You do not have to make changes.
Features are customized by entering a digit, as shown on the following pages. If the digit you
enter is valid, you will hear a confirmation tone and the indicator light(s) will reflect the new
setting. If the digit you enter is not valid, you will hear the error tone and the system will
remain ready to customize that feature until a valid digit is entered or you exit the feature.
No change will be made in a feature until you hear a confirmation tone.
After customizing a feature, you may do any of the following:
●
press the FEATURE button to customize another feature
●
press the ENTER ADMIN button to go back to STEP 5
●
hang up the receiver or press SPEAKER to exit customization
During customization, all the buttons on your 24-button set
at station 10 represent lines. Numbering starts at the lower
left with line 1 (see illustration). When you are customizing
a feature that is not changed on a line-by-line basis, the
Line 1 indicator light will show the current status of the
Line 22
Line 19
Line 16
Line 13
Line 10
Line 07
Line 04
Line 01
Line 23
Line 20
Line 17
Line 14
Line 11
Line 08
Line 05
Line 02
Line 24
Line 21
Line 18
Line 15
Line 12
Line 09
Line 06
Line 03
feature. When you are customizing a feature that is changed
Button Assignments
on a line-by-line basis (line selectable), the status of each line
During Customization
(Telephone Set 10)
will be shown on the indicator light for that line.
When you are customizing features that require a setting for each incoming line in the system,
you do not have to press the FEATURE button for each line. Press all the line buttons for
which you want the same setting.
EXAMPLE: Your system has the capacity for 24 incoming lines. Lines 01 through 10 are
PBX/Centrex Lines.
Lines 11 through 20 are Outside Lines. Lines 21 through 24 are not used
(Unavailable).
PROCEDURE: Press FEATURE, then dial 4. Press line buttons 01 through 10. Dial 3.
Press line buttons 21 through 24. Dial 1
(You do not have to customize lines 11 through 20 because the installed setting is Outside
Line.)
The indicator light of a selected line button will flash rapidly to let you know which line you
are currently customizing. If you have selected a line and then change your mind and do not want
to customize that line, simply press the line button again.
Administration Manual 15
