Music-on-Hold Audio Source
If you use equipment to broadcast certain copyrighted
music or material, including songs or other material from
radio broadcasts, you may be required to obtain the
permission of the copyright owner. One way to obtain
permission is to contact ASCAP, BMI, and/or similar
performing rights organizations, to obtain a license.
Lucent Technologies disclaims any liability arising out of
the failure to obtain such a license, if required.
For alternative (usually pre-licensed) sources of music to
use with this feature, you may wish to contact
Telephonetics International, Inc. at 1 800 446-5366. Or,
you can purchase a Magic On Hold system from Lucent
Technologies, which does not require you to obtain a
license.
1
2
3
4
First set the unit’s volume to the lowest setting.
Use a flathead screwdriver to turn the volume
control on the processor module counterclockwise
until it stops.
Insert an RCA phono plug into the MUSIC ON HOLD
jack on the primary processor module.
Route the cord as you did for line and extension
cords, then connect it to the audio source.
Place a call on hold and listen while adjusting the
volume, clockwise. If you do not hear music at any
setting, check “Music On Hold (#602)” in Chapter 5
of the PARTNER
II
Communications System
Programming and Use guide.
Volume Control
MUSIC ON HOLD
Jack
Audio Source
(optional)
Installation Procedures
17
