6
Install the down rod
1. Loose ball joint.
2. Feed down rod through ceiling canopy.
3. Insert the motor wires through down rod, and then secure
ball joint back to down rod.
4. Insert down rod to hanger (see Fig.4), line up hanger
holes with down rod holes and insert bolt. Then insert pin
to end of bolt.
5. Finally secure down rod and hanger via tightening two
screws on the hanger.
Blade attachment
1. Before Installing the blades, remove the motor screws.
2. Assemble the blades & holders using the screw set. (Fig. 5)
3. Secure the blade on the motor by using 2 screws with washers to tighten it ensuring they are
tightened simultaneously. (Take care not to over tighten as this can damage blades) (Fig.6)
Once completed, repeat the process on remaining blades.
BLADE INSTALLATION
Fig. 4
Fig. 6
Fig. 5
