Installation Instructions
SKU# 230722, 230723, 230724, 230725
(LD-EX3083G-BK, LD-EX3083G-WH, LD-EX3083G-BE, LD-EX3083G-SL)
Rated Voltage 220-240V~ 50Hz
THANK YOU FOR PURCHASING THIS QUALITY LUCCI PRODUCT. TO ENSURE CORRECT FUNCTION
AND SAFETY, PLEASE READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY BEFORE USING THE
PRODUCT.
WARRANTY:
•
This light fitting is covered by a 12 month warranty; please retain proof of purchase and evidence of
installation by a licensed electrician.
•
Warranty will be void if there is any damage due to improper usage or modification to the fitting.
INSTALLATION REQUIREMENTS:
•
Must be installed by a licensed electrician.
•
All wiring and installation of the light fitting must adhere to local and national wiring rules.
eg. AS/NZS 3000:2007/Amendment 2:2012 Electrical installations.
•
This fitting is rated IP44. This must be maintained during installation.
•
Select a suitable location for installation;
-
The mounting point must support 2 times the weight of the fitting.
•
Do not exceed the maximum wattage rating
•
The fitting must not be used without the glass or when the glass has been damaged.
•
If the glass is damaged, it should be replaced immediately.
•
Take care not to pull any electrical wires during unpacking as this may damage the connection.
•
Lay out all the components on a smooth surface and make sure there are no components missing
before assembling.
•
Check whether the fitting has been damaged during transport.
Do not operate/install any product which appears damaged in any way.
Return the complete product to the place of purchase for inspection, repair or replacement.
INSTALLATION DIRECTIONS:
1. Ensure all power to the circuit you are working on has been switched OFF.
(figure A)
2. Remove the housing and glass from the fitting by loosening the screws on the sides.
3. Use the fitting as a template to mark the screw positions onto the wall.
4. Drill holes into the wall and push the plastic screw anchors into the holes.
Ensure the plastic screw anchors used are suitable for the mounting surface.
5. Remove the lamp holder and the end cap from the bracket. (figure B)
6. Connect the mains supply wire to the lamp holder and ensure the ES lamp holder polarity is correct.
(figure B)
7. Connect the earth wire to the earthing point on the fitting.
8. Reinstall the lamp holder and the end cap onto the bracket.
9. Install the fitting onto the wall by using appropriately sized mounting screws. (figure C)
Ensure the mounting screws used are suitable for the mounting surface.
10. Install a globe (not included) into the lamp holder. Do not exceed the maximum wattage rating. (figure D)
11. Install the glass and housing back onto the fitting and tighten the screws on the sides.
12. Turn the power to the circuit back on. (figure E)
Содержание LD-EX3083G-BK
Страница 3: ......
