Installation Instructions
4 |
P a g e
Fig. 4
NOTE:
Fan installation must be complete including assembly of blades before operating the remote control.
NOTE:
This remote control is only suitable where the controller/receiver can be inserted inside the canopy cover safely
and securely. Ceiling fan with mount bracket type shown in Fig. 4 would be suitable.
NOTE:
The controller wiring circuit must NOT be shared with any electrical equipment that is sensitive to voltage
fluctuation, such as infrared sensor lights.
DO NOT use the wiring of the controller, other than for the purpose of supplying power into the controller and
connections to the equipment that is under control. Any outside wiring connections which are not part of the
controller/controlled circuit, may affect the operation of the controller and will void warranty.
NOTE:
The maximum ceiling pitch angle should not be exceeded. It will damage the receiver and result in electric shock.
Please check with the retailer about the maximum pitch angle suitable for ceiling fan with remote control.
If the remote control device is to be installed with an existing ceiling fan with any of the above wall manual fan controls,
PLEASE replace fan wall controller with the double pole ON/OFF switch.
Note:
A double pole wall switch must be included in the wiring installation. The double pole switch allows the remote
controller to disconnect from the mains 240VAC power during maintenance and cleaning of the ceiling fan.
