Installation Instructions
2 | P a g e
v 2 . 0 ( 0 3 / 2 0 1 8 )
Installation Directions
Remove all packaging material from the fitting.
1. Turn the power off before commencing the installation. (Fig.1)
2. Cut an installation hole using the dimensions given in the specifications table of the last page. Then insert the plastic
mounting bracket into the installation area. (Fig.2) Proceed to step 3.
USING LUCCI WIRING KIT AND LUCCI TRANSFORMER (both sold separately)
3. Remove the cover from the connector on the wiring kit (SKU# 220826, 220827 – sold separately).
Connect the fitting to the wiring kit. NOTE: The wiring kit is rated for a 120VA load only.
Connect the wiring kit (SKU# 220826, 220827 – sold separately) to the transformer (SKU# 220818, 220819,
220829 – sold separately). NOTE: The transformers are rated for 80VA, 28VA and 10VA load respectively.
(Fig.3 & 4)
Insert the fitting into the plastic mounting bracket and ensure it is secure and does not come out easily.
Proceed to step 5.
USING OTHER WIRING AND TRANSFORMER (not included)
4. Remove the 12V bi-pin connector from the cable for hard wiring or alternative wiring method and power supply
system. This fitting is rated IP65, this must be maintained during wiring and installation.
Ensure that the wires are secure and no bare wires are exposed. Ensure all wiring and transformer used is
appropriately rated and suitable for the location used. If unsure please contact a licensed electrician.
Insert the fitting into the plastic mounting bracket and ensure it is secure and does not come out easily.
Proceed to step 5.
5. Ensure all the clearance values are maintained during and after installation of this fitting.
Refer to the Installation Requirements section in this instruction manual for the clearance values.
Do not immerse the fitting, the transformer & the wiring kits in water. (Fig.5)
6. Turn the power on and test the fitting is operating correctly. (Fig.6)
