7.4 Setup for installation
You can install two units with fans in one row (B = 1630 mm) side by side (note the minimum distances
Figure 15: Fans in one row, wall higher than unit height
on page 44). Check the leg height. When
necessary, install the units on a platform.
If the wall is lower than the unit, the minimum distance between the unit and the wall is 0.5 x the minimum
distance with a higher wall.
If the units are surrounded by 3 or 4 walls, the minimum distances are longer. Check them according to the
amount of units and their air flow.
Note:
In exceptional cases, contact the product supplier or manufacturer.
7.3.2 Multiple units
We recommend installing units with high mounting leg side by side in one common group.
Contact Alfa LU-VE sales representative for more information.
7.4 Setup for installation
Horizontal air flow models (induced fans)
You can install the horizontal air flow models directly. Remove the lifting lugs.
Vertical air flow models (induced fans)
When mounting a vertical air flow unit, install the legs in the correct height. If the unit is installed directly on an
even surface, the height of the legs from the surface to the lower edge of the unit is ca 620 mm. Install also
the horizontal supports for the legs. See
Figure 17: Installation with legs
on page 45.
When you install the unit on a basement, install the legs in a steady middle position (ca 420 mm), without the
horizontal supports. See
Figure 18: Installation on basement
on page 46.
Figure 17: Installation with legs
©
Alfa LU-VE, Rev-04
45
Alfa LU-VE is a trademark registered and owned by LU-VE Group.
Alfa LU-VE reserves the right to change specifications without prior notification.
