LU-VE AlfaSolar S, Инструкция по эксплуатации

Страница: 26 / 90

6.2 Unloading unit from standard truck
Before starting lifting, make sure that
The ground under the unit has enough bearing capacity.
The device is correctly erected and horizontally installed.
The support legs are in supporting position.
The lifting capacity of the device is sufficient.
The operators know how to use the lifting device according to the operation and safety
instructions.
No electric or other cables are near the lifting place.
The working area of the lifting device is sufficient and safe.
There are no obstacles or risks on the working area.
In Figure 6: Units packed in different positions on page 26, on the left there is a unit packed in an upright
position. In the middle, there is a unit packed in horizontal position. On the right, there is a unit with forced
draught (FD) fans, delivered in the operation position.
Figure 6: Units packed in different positions
Both in upright and horizontal transport position, the vertical air flow unit with has its legs fixed to the pallet.
The legs are installed in the transport position. The lifting/turning lug, turning supports and horizontal leg
support are delivered loose in the same package. The lifting/turning lugs and turning supports (not included in
the FD units) are only delivered with the models packed in an upright position.
A horizontal air flow unit, packed in an upright position, is fixed to the pallet with a mounting rail. The lifting lug
is delivered loose in the same package.
When you lift the package with a forklift truck, use the lifting point at the lengthwise center of gravity and
ensure that it is in the middle, between the forklifts. When lifting a long unit, position the forks to the maximum
width over the area supported by the pallet.
Caution:
Check that the unit is tied tightly to prevent it from moving during transport. Ensure that the
binding does not damage the unit.
6.2 Unloading unit from standard truck
Unload the unit from the side of the truck with a forklift. See Figure 5: Correct lifting of AlfaSolar S/SR
™
units
with forklift on page 25.
For general instructions to unload the unit from container, see Unloading horizontal unit from container
(Container on ground level) on page 27, Unloading horizontal units from container (Container on wheels)
©
Alfa LU-VE, Rev-04 26 Alfa LU-VE is a trademark registered and owned by LU-VE Group.
Alfa LU-VE reserves the right to change specifications without prior notification.