- 5 -
GDPD400_V0.3_0920
1.2
Explanation of symbols
Warning notices and important information are marked in this document with symbols for better
identification.
The notices begin with signal words that indicate the extent of the danger. You must absolutely comply
with these notices and information and handle the device with care to prevent accidents and avoid per-
sonal injury and property damage.
DANGER
Notice indicating a dangerous situation which, if not avoided,
will result in death or severe injury.
WARNING
Notice indicating a dangerous situation which, if not avoided,
could result in death or severe injury.
CAUTION
Notice indicating a dangerous situation which, if not avoided,
could result in minor to moderate injury.
Attention
Notice indicating a dangerous situation which, if not avoided,
could result in property damage.
Note
Notice including useful tips, recommendations and information for efficient
and trouble-free operation of the digital pressure gauge.
1.3
Intended use
The GDPD 400 high-pressure tester is used for static and dynamic fuel pressure measurements on Otto
direct injection systems within the permitted ranges with the vehicle at a standstill and the engine cold.
WARNING
Danger from improper use.
Any improper use and failure to observe safety and operating notices can result in serious
malfunctions as well as personal injury and property damage.
– Only use the GDPD 400 high-pressure tester in accordance with its intended use.
– All information in the operating instructions and safety data sheets must be strictly complied with.
1.4
Disclaimer
Failure to comply with the intended use will immediately void any warranty and guarantee claims against
the manufacturer. No liability is accepted for damage or malfunctions caused by improper use, assembly
errors or failure to observe the operating instructions.
1.5
Ambient conditions
The GDPD 400 high-pressure tester is only to be used in commercial workshops.
The climatic requirements correspond to the conditions typically prevailing in Central Europe. Optimum
function is ensured between -10 °C and +45 °C. The device must be stored within a temperature range of
-20 °C to + 60 °C.
The GDPD 400 high-pressure tester and its components must be secured against falling.
