———————————————————
Zubehör von
—
Das Original
——
Rev. 02 31/03/2021
Seite 6 von 9
Instructions for rerouting cables hoses and wiring harnesses:
Throttle cables:
Route as original. Check throttle cables for free movement over the whole steering
angle and readjust the cables’ slackness, if necessary.
Brake hose:
Mount attached brake hosewith new seal rings.
Mind the mounting instructions
that are delivered with the brake hose.
Model w/o ABS:
Connect 20° fitting to the master brake cylinder, as shown. Then route the brake
hose as original.
Model w/ ABS:
Fit the attached hose with one seal-ring to the manifold first (view picture for the
alignment) and tighten it. Then mount the manifold with original bolt on the bracket.
Connect steel
tube with attached olive to the manifold.
Then connect the hose to the master cylinder, as shown
Clutch cable:
Route as original.
Wiringharness:
Reroute right harness behind the slider-tube. Pull left harness slightly out of the
frame and route as original.
Make sure that no cable, hose or harness is bended and stays tension-free over the whole
steering angle.
The conversion kit
is now completely mounted. Always check local laws and your manufacturer’s
warranty conditions for using aftermarket parts on your bike!
Ride safe and have fun!