——————————————
Zubehör von
—
Das Original
——
Rev. 00 20/11/2017
Seite 5 von 12
Fitting Instruction
P/N :
110B058
Product :
Rear Set
Brand :
BMW
Model :
RnineT Racer (1N12) 2017-
Important clue:
Read this instruction manual carefully and mind all warnings and tips. You should do this work
only if you‘re qualified; otherwise we recommend this mounting to be done by a qualified
workshop. Improperly mounting of this kit can reduce the driveability of the motorcycle and may
be a risk to your health and life. Test brake and gear shifting indoor, after installing rear set. If
anything is not operating properly or braking efficiency is poor, testing on the road may result in
death or serious injury!
Special works are marked with the following signs. Please take special care on these works.
Warning! Important mounting instruction. It shows risks to your life and
health.
Tips for mounting and maintenance or to avoid damage.
Rear sets are delivered pre-assembled! All fastening elements, which are not used
for mounting or adjusting the rear set, are fitted with tightening torque and bolt
adhesive. Those fastening elements are not mentioned in this instruction. All
mentioned fasteners, which are not secured by counter- or self-locking nuts, should
be installed with medium bolt adhesive (e.g. Loctite 243).
The tightening torques for connections to the frame refers to the manufacturer’s instructions.
Use the following torques for all the other bolted connections:
M5
=
6Nm
=
4.43lbf ft
M6
=
10Nm
=
7.38lbf ft
M8
=
20Nm
=
14.75lbf ft
M10x1,25
=
30Nm
=
22.13lbf ft
Maintenance:
Periodically proof all functions during service intervals. Use
particle free (no MoS
2
)
lithium or barium grease to maintain lever bushings.
Dismantling:
First loosen the plug connection to the brake light switch.
Then disassemble the gear shift lever and the original rear set
.
Cut the auxiliary lever of the side stand with a suitable tool flush with the side stand pipe off and
seal the interface to prevent corrosion.
Do not open the rear brake line!
