LSI Symbios SYM22801, Руководство пользователя

Страница: 39 / 80

SCSI Bus Termination 2-25
Figure 2.18 Termination Override Switch Settings for U1 and U2
2.3.5 Setting SCSI IDs
You must set each SCSI device and the host adapter to a separate SCSI
ID, 0 through 15. SCSI ID 7 is the preset host adapter setting, giving it
the highest priority on the SCSI bus. If you plan to boot your computer
from a SCSI hard disk drive on the SCSI bus, that drive should have
SCSI ID 0, or the lowest SCSI ID on the bus. Chapter 3, Configuring the
Host Adapter, explains how to set the host adapter ID using the Symbios
SCSI Configuration utility.
1
2
3
4
Default setting. Autoterm ination w ill
w ork as designed.
NO
1
2
3
4
NO
Sim ulates a device on the Internal 50 pin
connector. Use this switch only w hen a
device is connected to the internal 50 pin
connector that does not ground pin 22,
like another LSI Lo gic host adapter.
1-INT50
1
2
3
4
NO
Sim ulates a device on the Internal 68 pin
connector. Use this switch only w hen a
device is connected to the internal 68 pin
connector that does not ground pin 50,
like another LSI Lo gic host adapter.
2-INT68
1
2
3
4
NO
Forces term ination O N the upper data
lines. Use this sw itch w hen a narrow 8-bit
device is connected to one of the 68 pin
connectors.
3-UPPER TER M
1
2
3
4
NO
Sim ulates a device on the External 68 pin
connector. Use this sw itch only when a
device is connected to the external 68 pin
connector that does not ground pin 50,
like another LSI Logic host adapter.
4-EXT68