LSI 630J, Руководство по установке и обзору

Страница: 38 / 46

Turning on the Power and Checking for Problems . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-8 630J Storage Enclosure Installation and Overview Guide
ID Diagnostic Codes on the Seven-Segment Display
During normal operation, the ID display on each ESM displays the storage enclosure ID.
The Diagnostic Light (lower-digit decimal point) is on when the display is used for
diagnostic codes, and off when the display is used to display the storage enclosure ID.
NOTE
If a power-on or reset occurs, the Diagnostic Light, the Heartbeat Light
(upper-digit decimal point), and all seven segments of both digits are on. The
Diagnostic Light remains on until the storage enclosure ID displays.
Table 4–6 Supported Diagnostic Codes
Diagnostic Code ESM State Description
.8, 8., or 88 Suspended This ESM is being held in reset by another ESM.
L0 Suspended The ESM types are mismatched.
L2 Suspended A persistent memory error has occurred.
L3 Suspended A persistent hardware error has occurred.
L9 Suspended An over-temperature condition has been detected in
either the ESM or the power supply.
LL Suspended The midplane SBB VPD EEPROM cannot be accessed.
Ln Suspended The canister is not valid for this storage enclosure.
LP Suspended Drive Port Mapping Tables are not found.
H0 Suspended An ESM Fibre Channel interface failure has occurred.
H1 Suspended An SFP transceiver speed mismatch (a 2-Gb SFP transceiver
is installed when the storage enclosure is operating at 4
Gb) indicates that an SFP transceiver must be replaced.
Look for the SFP transceiver with a blinking amber LED.
H2 Suspended The ESM configuration is invalid or incomplete, operating
in Degraded state.
H3 Suspended The maximum number of ESM reboot attempts has been
exceeded.
H4 Suspended This ESM cannot communicate with the alternate ESM.
H5 Suspended A midplane harness failure has been detected in the
storage enclosure.
H6 Suspended An ESM firmware failure has been detected.
H8 SFP transceivers are present in currently unsupported ESM
slots, either 2A or 2B. Secondary trunking SFP transceiver
slots 2A and 2B are not supported. Look for the SFP
transceiver with the blinking amber LED, and remove it.