(10) Technically maximum permissible mass
When working with front loader or rear heavy loaded attachments installed to the 3-point linkage,
install ballast weights on the counter-part axle to maintain the front and rear weight balance of the
tractor. If not, front or rear axle can be strained by the overloaded weight.
When working with the front loader, place the attached rear weight to the highest position and turn
the down speed control knob to the “lock” position.
All models
Remarks
Technically total maximum
permissible mass
1608kg (3545 lb)
without consideration of the load
capacity of the tires
Front axle (*)
608kg (1340 lb)
Rear axle
1000kg (2205 lb)
▶
Maximum permissible mass is measured with only the front or rear wheels on the
* includes front mounted equipment or loader in the raised position but without load in the bucket.
Restrict operation
: In case of driving speed does not exceed 8km/h (5 mph) and standard
front/rear wheel track (
See next page
), Intermittent maximum permissible load of the front axle can
be ;
1200kg (2646 lb) for all models - without consideration of the load capacity of the tires.
4
4
4
4
- 15
scales inclusive of ballasts and with mounted equipments in the raised position.
▶
Do not exceed the maximum permissible mass above. Overloaded condition may
invalidate the warranty and may exceed the load rating of the tires.
▶
If the load capacity of the tire is lower than maximum permissible mass of the front
axle, the maximum load on the front axle meets the load capacity of the tire.
(
See page 4-16
)
▶
DO NOT change the setting pressure of the relief valve arbitrarily to increase the
lift capacity of the front loader or 3-point linkage. It can cause fatal damage to the
hydraulic system and front axle.
Caution
