LS tractor 30139708, Руководство оператора

Страница: 6 / 90

4
SAFETY PRECAUTIONS
Understand that your safety and the safety of
other persons are measured by how you service
and operate this backhoe. Know the position
and operations of all controls before you they
to operate.
Make sure you check all controls
in all safe area before starting.
▶ Read this manual completely and thoroughly
And make sure you understand all controls.
All equipment has a limit Make sure you are
aware of the stability and load characteristics
of this backhoe before you begin operation.
The safety information given in this manual does
not replace any safety codes, insurance needs,
federal, state and local laws. Make sure your
machine has the correct equipment required by
your local laws and regulations.
This safety alert symbol indicates important safety messages in this manual.
When you see this symbol, carefully read the message that follows and
be alert to the possibility of personal injury or death.
SAFETY PRECAUTIONS
Before starting the engine of your tractor, make
sure, all operation controls are in park lock or
neutral position.
Operate controls only when seated in the
operator's seat.
Equip your tractor with a ROPS cab or frame
for your protection. See your tractor operator's
manual for correct seat belt usage.
A frequent cause of personal injury or death is
persons falling off and being run over. Do not
permit others to ride on your tractor. Only one
person, the operator, should be on the machine
when it is in operation.
Before leaving the tractor, stop the engine, put all
controls in neutral, engage the parking brake and
remove the key from the ignition.
When using remote hydraulic tractor valves on
some tractors, the backhoe lift and dump cylinders
will continue moving unless the control levers are
manually returned to neutral, or until relief pressure
is reached at the ends of piston strokes. Observe
the bucket movement and maintain control with
the control levers.
Stop the backhoe arms gradually when lowering
or lifting loads.
Stay off slopes too steep for safe operation.
Shift down before you start up or down a hill
with a heavy load. Avoid "Freewheeling"
Travel speed should be such that complete
control and machine stability are maintained
at all times. Where possible, avoid operation near
ditches, embankments and holes.
Reduce speed when turning, crossing slopes,
and on rough, slick or muddy surfaces.
Never use your hand to check for suspected
leaks under pressure. Use a piece of cardboard
or wood for this purpose. Escaping hydraulic oil
or diesel fuel leaking under pressure has enough
force to penetrate the skin and cause infection or
other injuries by leaking fluid. If this occurs seek
medical attention immediately.
To prevent personal injury, relieve all pressure
before disconnecting fluid lines.
Before applying hydraulic pressure, make sure
all hydraulic connections are tight and
components are in good condition.