33
1.
Please turn on power after taking out a battery and put it again.
If it is not turned on, go to No. 2…
2.
Please charge a terminal. Please press a Power button in a charged state.
If the power is not turned on even with the Power button, please press a Reset Home.
If the power is turned on, please buffer it.
Q. The power was not turned on.
Q. Even if the power of a battery remains, the screen is not turned on.
A. It occurs when a battery is not properly entered or the cover is not closed.
1.
Please open the battery cover again and properly insert the battery well.
And please press the Power button.
If the screen is not turned on continuously, please press the Reset Home.
If the screen is not turned on in spite of doing the above action, the battery discharge
might be taken place.
Please charge the terminal.
Q. The terminal is often turned off.
A. When it is a battery use mode, it is a case that Power Off was set automatically.
1.
Execute power properties by pressing the Battery Icon at the Task Bar.
2.
When “If the idle state continues for the following time in case of using the battery power,
it is complete” is set at the Power Off Tab, it becomes automatically Power off if the
terminal is not used and the set time passes by in case of using battery power.
<!>
The present action is recommended as a menu saving battery consumption.
Q. When the power of a battery is very low, the Phone, WiFi, RFID, Image Demo doesn’t act.
A. It is normal action.
The power consumption is high in case of Phone, WiFi, RFID, Image Demo action
This is an action made for saving battery consumption and stability of a terminal.
3.
Wireless LAN
Q. The Internet is not connected.
A. If the network is not connected even when the wireless LAN is turned off or on, the
Internet isn’t connected.
1.
Please turn on the
wireless LAN and connect the network.
Please refer to the part of
wireless LAN Manual.
If the Internet is not connected continuously, go to No. 2…
2.
If its sensitivity state is not good much, the Internet might be not connected.
Open Summit Client Utility, move to Status Tab and confirm Signal Strength.
When the sensitivity is close to -70dBm or lower, please raise its signal intensity more by
moving the region.
