LR ZeitGard, Инструкция по эксплуатации, Страница: 10 / 106

18 19
B B
Face cleansInG
CAUTION! Continuously move the brush, do not treat the same location
for a longer time, and apply only light pressure. Pressing too hard and
remaining at the same location can cause skin irritation. Immediately stop
the treatment if you feel pain.
1. Moisten your skin with water.
2. Apply cleansing cream or gel to the moistened brush.
3. Switch the unit on after placing it onto the skin. Then move the brush
continuously with gentle movement over the skin.
4. Clean each patch of skin for approx. 20 seconds and then move the
brush to the next skin patch.
ATTENTION : Do not use the appliance for the sensitive skin around the
eyes.
Note:
• Every 20 seconds, the appliance pauses for a short time to indicate
the end of cleansing of a skin patch.
• After 1 minute of operation, the appliance emits a beep and switches
to standby mode. The indicator LEDs remain lit. The cleansing process
can be continued by momentarily pressing the ON/OFF switch. In that
case, the appliance operates for another minute at the st speed.
• After another 2 minutes without any settings, the appliance switches
off automatically. A beep can be heard.
5. Press the ON/OFF switch for approx. 3 seconds to turn the appliance
off.
6. Rinse the treated skin with lots of clean water.
7. Apply your facial cream as usual. At this point, do not any substance
that could irritate your skin.
OPeratIOn
Cleaning brush
•
To install an attachment slip it onto the
hexagon until it engages with a click, and pull
it off to remove it. After attaching a new brush
attachment, check that it has engaged the
hexagon correctly.
•
For hygiene reasons it is recommended:
– not to share the appliance with other people.
– to replace the brushes every 3 months.
Turning ON/OFF and Mode Selection
• Press the ON/OFF switch for approximately 3
seconds. The lamp on the ON/OFF
switch light green and the appliance
runs at the lowest speed, indicated
by the lowest LED.
Instructions
The appliance always starts at the low-
est speed when it is switched on.
• Press the ON/OFF switch momentarily to
select the desired speed. The set speed is indicated
by the corresponding speed indicator LED. The
lowest LED indicates the lowest speed, the center
LED the medium speed, and the top LED the
highest speed.
• Every 20 seconds, the appliance stops operating
for a short time. At that point, a beep can be heard.
After 1 minute of operation, the appliance switches
to standby mode. In doing so, an LED flashes –
depending on the selected speed. After another
2 minutes, the appliance switches off automati-
cally. When you press the ON/OFF switch
momentarily in standby mode, another 60 seconds
cycle starts in the most recently selected speed.
• Press the ON/OFF switch again for approx.
3 seconds to turn the appliance off. All indicator
LEDs go out.
• In the case that the battery is completely drained, the
appliance beeps several times and then switches off
completely. In that case, place the appliance again
into the charging station.