Setup
ProtoMat M60
19
5.5 After switching on
When it has been switched on, the equipment moves to limit switches -X
and -Y, and the system then halts in the tool change position. It is then
able to accept commands from the machine drivers. If the equipment
does not move when it has been switched on, check the following:
1.
Is the POWER LED on (is on only after successful initialization)?
2.
Are all cables properly inserted ?
3.
If necessary, check the fuses at the input power connection!
5.6 Function test with BoardMaster
Danger! Make sure that nothing is no other persons are in the
machine operating area when the first functional test is taking
place!
First check that the serial interface used is set to
9600 baud, 8 data
bits, 1 stop bit, no parity bit and hardware handshake
and FiFO-
buffer off
. Also check that
CHANNEL
and the correct interface have
been selected in
BoardMaster
under
MACHINE CONNECT...
Consult
the
BoardMaster
Manual if you need help.
Now using
BoardMaster
:
› The correct tool must be declared (clicked on) in the window
TOOL-
ASSIGNMENT
› Before the motor can be switched on, the milling head has to be
moved out of the tool-change position a few inches using the cursor
key.
› turn on the motor, to click of
(first the motor will turn at a
maximum of 20,000 rpm, warm up phase)
› raise/lower the head, to click of
› switch off the motor, to click of
› move the head manually using the cursor keys on the
BoardMaster
function bar.
If the equipment does not move, check the interface configuration, the
connecting cable as well as the PC interface.
