I-20
of 20
P.O. BOX 3448 • OMAHA, NEBRASKA 68103-0448 • (800) 228-9882
0-3F
REV. AL
5954
6/2007
Lozier® Corporation 2007
11.
Install Base End Trims, Uprite
End Trims and Top Rails.
Top Rails - Tabs on Top
Rail must lock in place.
BET - Slide over Base Bracket until
Stop Tab on BET rests on top of
Base Bracket (see Detail below).
Hook top of Uprite End Trim
over top of Uprite, then press
on working toward floor.
12.
Install Base Decks and Shelves as shown. Be sure Base End Trim (BET) is installed before installing Base
Decks (see Step ). Refer to
Allowable Shelf Load Limits
on page I-3 for shelf information.
To install Decks, tilt
upward and hook rear
molding behind deck hold
down pin.
Deck Hold
Down Pin
Deck must sit on
lock tab on BET
IMPORTANT
See Plan View of Base Bracket above
for seating Base Bracket End Trim
1.
Insert front flange into front
of BB adjacent to the CBF
2.
Put rear flange against
BB hook slide shown
Plan View of
Base Bracket
BET must slide behind front and
rear flanges on Base Bracket to
be properly seated
IMPORTANT
Base Bracket End Trim (BET)
must
be installed
before
installing Base Decks.
Island Section Installation
NOTICE:
If Trim or Shelves do not fit properly, check to be sure unit is leveled properly.
If the Uprites are not plumb and/or at proper height, redo Step 7, page I-8.
