LOYTEC L-STAT, Руководство пользователя

Страница: 55 / 61

L-STAT User Manual 55 LOYTEC
Version 1.0 LOYTEC electronics GmbH
5.2 Remote Control Pairing
Each remote control has an ID that is transmitted along with the button code. This ID can be
used to pair a certain remote control with a certain L-STAT device. The ID of the Apple
remote control can be changed by pressing Menu and Center button for at least 6s. This will
increment the ID by one.
The ID of your remote control can be checked by pressing any button and watching the
ir_remote_control_command register in the Web interface as shown in Figure 12 below.
This example shows that the Menu button was pressed on a remote control with the ID 14.
Figure 12: IR Remote Control Command Register
If an L-STAT device gets paired with a certain remote control it will only update the
ir_remote_control_command register and the IRC bit at the short_pressed register when
receiving a command from this remote control. So an L-STAT device can only be paired
with one remote control but a remote control can be used for multiple L-STAT devices.
Pairing can be achieved by pressing Menu and Right button at the remote control for at least
6s while pointing towards the L-STAT device. If pairing worked the secondary display will
shortly show ‘
IRP
’ (IR pairing). The remote ID will be saved internally and the IRCP flag of
the config_flags register at address 192 (Table 22 at Page 33) will be set.
The pairing can be canceled by either clearing the IRCP flag or by pressing Menu and Left
button for at least 6s. If the secondary display shows ‘
IRUP
’ (IR unpairing) shortly the pairing
is suspended.