8
Step Mount
Mounting the StructureScan transducer under the step not only protects the
transducer from hitting objects in the water, but does not cause any drag on your
boat when it is on plane.
Step Mount Supplies (not included)
1/8” Drill bit (Transom mount pilot holes) Marine grade above- or below-
waterline sealant
To use Step Mount:
Choose a transducer location.
1.
Route the transducer cable to the location where the LSS-1 will be
2.
installed.
Move the transducer bracket into the desired position and then use
3.
a pencil to mark the pilot
holes through the slots in
the bracket.
Drill the pilot holes.
4.
Apply a high-grade above-
5.
or below-waterline sealant
to the pilot holes.
Align the bracket slots over
6.
the pilot holes and fasten
the bracket to the transom
using your drill and the
supplied screws.
To make adjustments to
7.
transducer position, loosen
the screws and slide
bracket up or down.
Connect the transducer cable to the LSS-1 sonar port.
8.
StructureScan transducer mounted
under the step.
Step
