Dimensions
Parts included
A
M8-1.25, flange nut, 316 ss (x2)
B
M8 washer, 316 stainless steel (x2)
C
M8 washer, nylon, M8, 8.5mm ID, 16mm OD (x2)
D
Flange nut, M33
E
M33 washer, 316 stainless steel
F
M33 fairing isolator washer, nylon
G
M8-1.25 x 185 mm stud, 316 ss
H
M8-1.25 x 150 mm, stud, 316 ss
I
Isolator sleeve, M8 (x2)
J
Isolator sleeve, M33
K
Fairing block
L
LiveSight thru-hull transducer
M
Documentation pack
A
Drill
B
Drill bits 9 mm (3/8”)
C
Hole saw 35 mm (1 3/8”)
D
Heat gun
E
Sandpaper
LiveSight thru-hull transducer
Installation Guide
Technical specifications
Environmental
Water temperature for
operation
0°C to +35°C
(32°F to +95°F)
Storage temperature -30°C to +70°C
(-22°F to +158°F)
Physical
Weight 2.3 kg (Thru hull without
fairing block)
0.84 kg (fairing block)
Cable length 7,6 m (25 ft)
Hull requirements
Dead rise angle 0 - 25°
Max hull thickness 5 cm (2”)
The most up-to-date specifications are available at the
product web site.
*988-12344-001*
Compliance statements
Europe
Navico declares under our sole responsibility that the product
conforms with the requirements of:
•
CE under EMC Directive 2014/30/EU
United States of America
¼
Note:
The user is cautioned that any changes or
modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
Australia and New Zealand
Navico declares under our sole responsibility that the product
conforms with the requirements of:
•
level 2 devices of the Radiocommunications
(Electromagnetic Compatibility) standard 2017
Declarations
The relevant Declaration of Conformity is available on the
following websites:
•
www.lowrance.com
•
www.simrad-yachting.com
Address
Navico Logistics Europe B.V.
Laan van Europa 450
3317 DB Dordrecht
The Netherlands
Required tools
M
J
K
A
B
E
H
I
I
G
F
D
C
A
B
C
ENGLIS
H
Installa
tion M
anual
bandg
.com
L
A
B
F
E
G
H
D
C
195 mm
7.7 “
112 mm
4.4 “
370 mm
14.6 “
132 mm
5.2 “
The Fairing block
A
Vessels with a dead rise angle > 10°
B
Vessels with dead rise angle < 10°
C
Minimum fairing thickness = 12 mm (0.5“)
The transducer must be mounted as parallel to the water
surface as possible.
For hulls with a dead rise angle, the fairing block should be
used to compensate for the dead rise angle.
A
B
C
C
F
Marine grade above
or below waterline
sealant
G
13 mm and 50 mm size
wrench
H
Band saw or table saw
