DSI Sonar
16
3. Hold the transducer assembly against
the transom. Look at the transduc-
er from the side. If it is parallel to the
ground, then the “A” position is correct.
4. If the transducer can not be adjusted
so its face is parallel to the ground, re-
move the transducer and ratchets from
the bracket. Reinsert the ratchets into
the bracket, this time with the letter “B”
aligned with the dot stamped in the
bracket. Reassemble the transducer
and bracket and place it against the
transom.
5. Repeat this process until the transducer
can be adjusted so its face is parallel
with the ground.
Mounting to transom
1. Adjust the transducer so its face is par-
allel with the ground and its center is
even with the bottom of the boat hull.
2. Hold the transducer and bracket as-
sembly against the transom. When the
transducer and bracket are properly
aligned mark its position on the hull.
0.TWEETY INSTALL_SONAR_DSI.indd 16
9/14/2011 11:55:42 PM
