6
ASSEMBLY INSTRUCTIONS
Yoke
Set Screw
Downrod
Downrod Clip
Downrod Pin
Motor
5. Remove the downrod clip and downrod pin from the
downrod. Then partially loosen the two set screws in the
yoke at the top of the motor.
5
Downrod Clip
8
7
6
Canopy
Motor
Downrod Pin
Set Screw
Downrod
Yoke Cover
Yoke Cover
Yoke
Downrod
6. Feed the wires coming from the yoke through the yoke
cover, canopy, and downrod.
7. Insert the downrod into the yoke and reinstall the
downrod pin and downrod clip. Then retighten the two
set screws.
Note: With wiring extending out of the downrod,
measure 8 inches of lead wire and cut the excess wire
with wire cutters (not included). Then strip 1/2” of
insulation from the end of each wire.
Tab
Slot
Downrod
Mounting
Bracket
8. Lift the downrod into the mounting bracket. Rotate the
downrod until the tab in the mounting bracket is seated in
the slot in the downrod ball.
WARNING: The fan and/or downrod should
not rotate in the mounting bracket if installed
correctly. Failure to align the slot in the downrod ball with
the tab may result in fan falling causing serious injury or
death.
