Step 6
While holding the bolt with a 13mm box
end wrench, tighten the nylock nuts
using a 13mm ratcheting box end
wrench. Tighten the second nylock nut
in the same way.
Step 5
Install both of the supplied M8 nylock
nuts.
Step 7
While holding the 12mm bolt using a
19mm box end wrench, tighten the
12mm nylock nut using a 19mm
ratcheting box end wrench until the nut
becomes tight. Then loosen the nut 3/4
of a turn.
Note: We loosen the nut so that the
stabilizer can pivot on the 12mm bolt.
Congratulations!
You have successfully installed the
a steering stabilizer bracket. We
hope these instructions have been
helpful. If you have suggestions on
how to make these instructions (or
products) better, please email us at:
