Lovibond SD 320 Con, Инструкция по эксплуатации, Страница: 33 / 60

33
SD 320_2 05/2015
2.3 Safety instructions
This device is built and tested in accordance with the safety regulations for electronic
measurement devices. The faultless function and operational safety of the device can only be
guaranteed if the applicable safety precautions as well as the device-specific safety instructions
in this manual are observed.
1. The function and operational safety of the device can only be adhered to under the
climate conditions specified in the chapter "Technical data". If the device is transported
from a cold environment into a warm environment, the formation of condensation
may bring about a fault in the device function. In this case, you must wait until the
device temperature has equalised with the room temperature prior to turning it on.
If it is to be assumed that the device can no longer be operated without potential
danger, it must be decommissioned and corrected by means of identification
prior to re-commissioning. The safety of the user may be diminished by the
device if it
- has visible damage.
- no longer works as prescribed.
- was stored for an extended period of time in unsuitable conditions.
In case of doubt, send the device to the manufacturer for repair or maintenance.
The instrument should only be connected to external devices with extreme care.
Under certain circumstances, internal connections in third-party devices (e.g. GND
connection with earth) lead to potential impermissible voltage which impairs the
function of the device itself or a connected device, or may even destroy said devices.
Do not operate the device with a defective or damaged mains adapter.
Danger of fatality due to electric shock!
This device is not suitable for safety applications, emergency devices or for use
where malfunction could cause injury and property damage. If this notice is
not observed, severe damage to health and property may occur.
This device may not be used in a potentially explosive environment. In
the event of operation in a potentially explosive environment, there is a
risk of deflagration, fire or explosion due to the formation of sparks.
!
!
!
!
2.
3.
4.
5.