CONNECTING MODEL TLSP-F / TLSP-W TO A LOUROE BASE STATION
The following procedure pertains to all Louroe Base Stations with
talkback
After wiring connections are made at Model TLSP, run recommended 4 conductor cable to the Louroe Base Station and
connect as follows. Connections are located at rear panel of the base station.
1) RED wire (12Vdc) goes to terminal “A” of Base Station (zone 1)
2) BLACK wire (Audio Output) goes to terminal “B” of Base Station (zone 1)
3) BARE wire (ground) goes to terminal “C” of Base Station (zone 1)
4) GREEN speaker wire goes to “TB” (talkback) terminal of Base Station (zone 1)
5) WHITE speaker wire goes to “G” (ground) terminal of Base Station (zone 1)
Repeat same procedure for the remaining zones
Microphone Connections
Located behind the speaker portion of TLSP is a PC board with a small terminal block marked A, B, C.
Using shielded portion of recommended wiring: 1) RED wire goes to terminal A (12 Vdc supply)
2) Black wire goes to terminal B (audio output)
3) Bare wire (drain) goes to terminal C (ground)
Speaker Connections
Mounted next to speaker is a 70V transformer with two lead wires GREEN (positive) and WHITE (ground). Using wire
nuts, connect these two wires to the unshielded GREEN and WHITE cables of recommended wiring (West Penn 356 or
equivalent)
MICROPHONE AND SPEAKER
WIRING CONNECTIONS FOR TLSP MICROPHONE AND SPEAKER
Page 2 of 4
LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406
TEL (818) 994-6498
FAX
994-6458
website: www.louroe.com e-mail: [email protected]
(818)
®
INSTALLATION AND OPERATING INSTRUCTIONS
tlsp_inst_3/15
SPECIFICATIONS (Model TLSP-F and TLSP-S)
Output of microphone (Mic)
Frequency Response (Mic)
Current Drain (mic)
Speaker
Line Level (0 dB, 600
W
@ 1K
W
)
40 Hz to 15 kHz
10 mA
3”, 2W w/ 70V transformer
Faceplate (TLSP-S)
Vandal Resistant
Stainless Steel
Faceplate (TLSP-F)
Backbox
Weight
Shipping Weight
6”L x 6”W
7”L x 7”W
6”H x 6”W x 4”D
4 lbs
7 lbs
