LOTRONIC 16-2044, Руководство пользователя

Страница: 4 / 28

EN 4 © Copyright LOTRONIC 2021
2. Connection of Signal Cable
You can use the 3-pin XLR cable to connect the output socket of the master and the input socket of
the slave light. Connect the DMX OUT socket of the master and the DMX IN socket of the slave light,
then, connect the OUT socket to the IN socket of the next light. Ordinal to connect all the lights as
below:
A DMX signal terminator is recommended on the last unit of the chain. DMX terminator is a XLR
connector with a 120Ω resistor between the pin 2 and pin 3 of the XLR connector
1 2
3
Ground
Signal (+)
Signal (-)
Signal (+)
Signal (-)
1 2
3
120
Ω
DMX512 IN DMX512 OUT
DMX IN
POWER IN
CONTROL PANEL
LCD DISPLAY
MENU
UP
DOWN
ENTER
Use Menu button to choose a function. Press Enter button to enter the menu of the selected func-
tion. Use the Up and Down buttons to select the parameters, then press Enter button to confirm
the selected parameter
Check the following function table :
MENU Description
DMX addr A001-AXXX DMX address setting
Auto Play
Auto run Internal Program 1-9 Master/Alone Auto Program
Music run Internal Program 1-9 Master/Alone Music control
Reset
ALL reset On/Off ALL reset
Scan reset On/Off Scan reset
Other reset On/Off Zoom Reset
Reverse Pan On/Off Reverse Pan
ReversTilt On/Off Reverse Tilt
Special Reset Default On/Off Reset Default
Calibrat Code (password: 088) Calibration code
PAN, TILT, ZOOM Calibration of the channel
Temperatur XXX°C/°F Current temperature
Manual Crtl PAN=XXX...... Manual control
Mic SET 0-99% Sensitivity of mic