12
OUTPUT CONNECTION
(
Figure A.3)
The plasma cutting torch and ground cable are supplied with the
plasma cutter. To connect the cables, turn the Power Switch “OFF”.
1.
Plug the major power connector (the wider wire) from the torch
cable to the “Cutting Torch” output terminal (
5
)
1
. Turn it clockwise
using the plastic safe protector until snug, do not over tighten.
2.
Plug the 2-prong connector from the torch cable into the 2-pin
socket marked as “Switch” (
7
). Turn the outer metal shell clockwise
to tighten.
3.
Connect the ground cable & clamp to the “Earth Clamp” output
terminal (
6
) and turn it clockwise to tighten.
To minimize high frequency interference, refer to
Machine
Grounding and High Frequency Interference Protection
section of
this manual for the proper procedure on grounding the work clamp
and work piece.
To avoid receiving a high frequency shock, keep the plasma
cutting torch and ground clamp & cable Insulation in good
condition.
1
The number inside “( )” is the annotation in section
Specifications
– Controls and Setting.
Содержание LT3200
Страница 1: ...LOTOS LT3200 Plasma Cutter ...
