Lorex Vantage LW2232 Скачать руководство пользователя страница 2

vi

 

Installation (Continued)

10. 

Ventilation

 - Slots and openings in the case are 

provided for ventilation to ensure reliable operation 
of the product and to protect it from overheating. 
These openings must not be blocked or covered. The 
openings should never be blocked by placing the video 
equipment on a bed, sofa, rug, or other similar 
surface. This product should never be placed near or 
over a radiator or heat register. This product should 
not be placed in a built-in installation such as a 
bookcase or rack unless proper ventilation is provided 
and the product manufacturer’s instructions have 
been followed.

11. 

Attachments

 - Do not use attachments unless 

recommended by the product manufacturer as they 
may cause a hazard.

12. 

Water and Moisture

 - Do not use receivers or video 

monitors near water — for example, near a bath tub, 
wash bowl, kitchen sink or laundry tub, in a wet 
basement, near a swimming pool and the like.

13. 

Heat

 - The product should be situated away from 

heat sources such as radiators, heat registers, 
stoves, or other products (including amplifiers) that 
produce heat.

14. 

Accessories

 - Do not place this 

video equipment on an unstable 
cart, stand, tripod, or table. The 
video equipment may fall, 
causing serious damage to the 
product. Use this product only 
with a cart, stand, tripod, 
bracket, or table recommended 
by the manufacturer or sold with 
the product. Any mounting of the product should 
follow the manufacturer’s instructions and use a 
mounting accessory recommended by the 
manufacturer.

15. 

Camera Extension Cables

 – Check the rating of 

your extension cable(s) to verify compliance with your 
local authority regulations prior to installation.

16. 

Mounting

 - The cameras provided with this system 

should be mounted only as instructed in this guide or 
the instructions that came with your cameras, using 
the provided mounting brackets.

17. 

Camera Installation

- Cameras are not intended 

for submersion in water. Not all cameras can be 
installed outdoors. Check your camera 
environmental rating to confirm if they can be 
installed outdoors. When installing cameras 
outdoors, installation in a sheltered area is required. 

Service

1. 

Servicing

 - Do not attempt to service this video 

equipment yourself, as opening or removing covers 
may expose you to dangerous voltage or other 
hazards. Refer all servicing to qualified service 
personnel.

2. 

Conditions Requiring Service

 - Unplug this 

product from the wall outlet and refer servicing to 
qualified service personnel under the following 
conditions:

A. When the power supply cord or plug is damaged.

B. If liquid has been spilled or objects have fallen into 
the product.

C. If the product has been exposed to rain or water.

D. If the product has been dropped or the cabinet has 
been damaged.

E. If the product does not operate normally by 
following the operating instructions. Adjust only 
those controls that are covered by the operating 
instructions. Improper adjustment of other controls 
may result in damage and will often require extensive 
work by a qualified technician to restore the product 
to its normal operation.

F. When the product exhibits a distinct change in 
performance. This indicates a need for service.

7. 

Replacement Parts

 - When replacement parts are 

required, have the service technician verify that the 
replacements used have the same safety 
characteristics as the original parts. Use of 
replacements specified by the product manufacturer 
can prevent fire, electric shock, or other hazards.

8. 

Safety Check

 - Upon completion of any service or 

repairs to this product, ask the service technician to 
perform safety checks recommended by the 
manufacturer to determine that the product is in safe 
operating condition.

Use

1. 

Cleaning

 - Unplug the product from the wall outlet 

before cleaning. Do not use liquid cleaners or aerosol 
cleaners. Use a damp cloth for cleaning.

2. 

Product and Cart Combination

 - Product and cart 

combination should be moved with care. Quick stops, 
excessive force, and uneven surfaces may cause the 
product and cart combination to overturn.

3. 

Object and Liquid Entry

 - Never push objects of any 

kind into this product through openings as they may 
touch dangerous voltage points or “short-out” parts 
that could result in a fire or electric shock. Never spill 
liquid of any kind on the product.

4. 

Lightning

 - For added protection of this product 

during a lightning storm, or when it is left unattended 
and unused for long periods of time, unplug it from 
the wall outlet and disconnect the antenna or cable 
system. This will prevent damage to the product due 
to lightning and power line surges.

Содержание Vantage LW2232





















Отзывы: