SPECIFICATIONS
WIRELESS CAMERA
Image sensor
Lens
Picture element
Scanning system
Battery Life (assume 1300mAH)
Current Consumption
Scanning frequency
Sync. system
Resolution
Min. illuminations
Video Output
Gamma characteristics
Auto Iris
Microphone
Transmitting frequency
Modulation
RF out level
Video Input level
Audio input level
Antenna
Oper. temperature
Power source
Dimensions
Weight
Receiving frequency
Output level
Sensitivity
Antenna
Oper. temperature
Power source
Dimensions
Weight
Basic system includes
B&W or Color CMOS
F2.0/f 3.7mm, 92
°
wide-angle lens
510 x 492 (Color), 320X240 (B&W)
2:1 interlace
3 Hours (Color); 4-5 Hours (B&W)
300mA typ. (color); 230mA typ (with LED)-
15.734 KHz(H) 59.9Hz(V) ,EIA
Internal Synchronization
240 Lines (B&W), 380 Lines (color)
0.Lux (B&W), 2 Lux (COLOR)
1.0Vp-p/75 Ohm
r=0.45
Electrical Auto Iris
Shutter sensitivity :1/60-1/100,000
Condenser
2.4 GHz-2.4835 GHz
FM
90dBu/V, 3m
1.0Vp-p/75 Ohm
2.0Vp-p/600 Ohm
Dipole antenna
-14º to + 122º F or (-10ºC to + 50 ºC)
DC12V 500mA DC Adapter
7.3 (W)
x4.7
(H)
x
11(D) cm or
2.8’ (W) x 1.85’ (H) x 4.3’ (D)
118 grams or 3.79 Oz
2.41GHz - 2.48GHz (4CH)
1.0Vp-p(Video), 1.35Vp-p(Audio)
-25dBm to -80dBm
Dipole antenna
-14º to + 122º F or (-10ºC to + 50 ºC)
9V 500mA DC Adapter
15.3(W)
x9
(D)
x
4.5 (H) cm or
6.02’ (W) x 3.5’ (D) x 1.77’ (H)
220 grams or 7.07 Oz
1- Wireless Camera
1- Wireless Receiver
2- AC Adapters
1- RCA A/V Cable
1- RF Cable
1- Owner's Instructions
1-Camera Mount
1- Battery box ( for camera)
Screws and anchors
WIRELESS RECEIVER
15
FCC CLASS B NOTICE
Note:
This equipment has been tested and found to comply with the limits For a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, Uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, (which can be determined by
turning the equipment off and on), the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio or television technician for help.
Because our products are subject to continuous improvement, SVC reserves the right to modify product
designs and specifications without notice and without incurring any obligation. E&OE
