Lorex LW1000 Series, Инструкция по эксплуатации

Страница: 11 / 17

Camera Installation
11
Installing the Camera:
1. Carefully unpack the Camera.
2. Decide whether the camera will be permanently wall mounted or sit on a
tabletop:
•
If you decide to place the camera on a tabletop or other flat surface,
the camera can easily be moved to different locations as desired. It is
strongly recommended that the camera be affixed to the table top
surface to prevent damage to the camera in case of tabletop surface
movement or improper handling.
•
If you decide to permanently mount the camera to a wall, make sure to
select a location close to a power outlet.
NOTE : Wireless cameras require a power source (either an electrical
outlet or battery power) to operate. If you plan to permanently mount the
camera in a location, it is recommended to use the included Camera
Power adaptor to prevent interruptions in the image, as the battery adaptor
is intended as a temporary power solution.
Wall Mounting Instructions (for the LW1001 and LW1002 ONLY)
To mount the camera to a wall:
1. Measure and mark the positions for the 2 screw holes on
the wall with a 0.90” space in between the 2 marks.
2. For Drywall:
•
Drill the 2 holes (1/4” drill bit) and insert the
drywall plugs as needed.
3. Screw in both screws until the base of both screw heads
are roughly 3mm from the wall.
4. Slide the base of the camera onto the screw heads.
NOTE: If the base is not flush with the wall: Remove the base from the screw heads,
and adjust the depth of the screws until the camera base is flush with the wall.
5.
Adjust Camera to the desired angle. If desired gently
tighten the screw on the neck of the camera until
snug.
Table Top Mount:
The Camera can be
placed on any flat
surface.
0.90”
5