Lorenzo SMS17102, Инструкция по эксплуатации, Страница: 9 / 16

9 Lorenzo
• Never use the machine to saw pieces of
work that are so small that they cannot be
secured safely.
• When sawing profile sections the work
must be carried out such that the piece of
work cannot slide away and the saw blade
cannot become jammed. A profiled piece
of work must lie flat or be held in place by
an attachment so that toppling or sliding
during the work is prevented.
• Round pieces of work such as tubes must
be well secured, otherwise these can
revolve and the danger exists that the saw
blade catches in them. Always keep the
piece of work on the table and against
the stop using a suitable accessory or
attachment.
• Make sure that the piece of work does not
have any nails or other foreign objects in it.
User safety
• Make sure you have a clean and tidy
working environment.
• Make sure the working environment is
well lit.
• The user of the machine must be
instructed in the use, adjustment and
operation of the machine.
• Use a dust mask or dust hood to prevent
the inhalation of (harmful) dust.
• Wear gloves when you exchange the
saw blade or when rough material is to
be sawn. It is best to keep saw blades
in a separate holder to prevent anyone
getting hurt.
• When the machine is equipped with
a laser, this may not be replaced by a
different type of laser. Repairs may only
be carried out by the laser manufacturer
or a recognised specialist.
• The operator should wear ear protectors
to reduce any damage to hearing.
• To prevent accidents occurring by the
accidental switching on of the machine,
the plug must always be pulled out of the
socket before adjustment of the stop or
the saw head is carried out,
when changing blades or accessories, and
when maintaining the machine.
• To prevent electric shocks, when plugging
the plug into the socket the metal
pins must not be touched in any way
whatsoever.
• Never use the cord to pull the plug out of
the socket. Keep the cord away from oil,
heat and sharp objects.
• Never apply a cleaning or lubrication
agent to a saw blade that is still revolving.
• To prevent fires, never use the machine in
the vicinity of flammable liquids, vapours
or gases.
• Always use original accessories: others
may cause wounding.
• Always choose the right saw blade in
relation to the material to be sawn.
transporting and moving
• Check that all locks and tensioning
devices are secure.
• Do not lift the machine by the extension
pieces (for the stabilisation of the saw),
but by the solid underside of the machine.
while the machine is in use
With frequent use of the machine, do not
let routine lead to mistakes. Remember that
a slight lack of concentration can lead to
serious injuries in a fraction of a second.
• Before beginning to saw, make sure
that the protective hood is in the right
position.
• Before cutting the first cut, let the
machine run for a short while. If you hear
any unusual sounds or observe any strong
vibration, turn the machine off and take
the plug out of the socket, and then find
the cause of the problem. Do not switch
the machine on again until the cause has
been found and the fault repaired.
• Make sure that the piece of work being
sawn off does not get stuck in place, do
not hold it or clamp it and no not secure it
against the stop. It must be able to move
freely along the side of the saw blade.