TABLE OF CONTENTS
E 6
LOREME
12, rue des Potiers d'Etain - 57071 Metz
03.87.76.32.51 - Fax 03.87.76.32.52 - Email: [email protected] - [email protected]
ADDRESS?
Press
‘
’
or
‘
’
buttons to modify the bus address.
1
‘Config’ button to validate.
2.5) Energy meters start value configuration
ENERGY ?
Press the
‘
’
(Yes) button to access the rubric.
(Y-N)
Press the
‘
’
(No) button to skip the rubric.
CONF. W CHANNEL?
It is possible to set the energy counter for a particular channel by selecting <ONE>
<ONE> ALL
or all channels by selecting <ALL>.
(In the same manner as the configuration of the currents).
2.6) End of configuration. Parameters saving
MEMORIZING
This message is display only when the user enter in COMMUNICATION menu.
OK!
This message indicate the end of configuration and that the parameters are saved in memory.
3) Configuration protection
It is possible to forbid the access to the device configuration's. When the "Password" function is activated, the user must
enter a 4 characters code to access the configuration mode.
3.1) Activating the function
When the device is in measure mode, press simultaneously on
‘
’
and
‘
’
buttons for at least 5 seconds.
The following message is displayed:
PASSWORD?
The buttons
‘
’
or
‘
’
change the selection.
YES <NO>
The 'Config' button validate the choice.
- <NO> : deactivating the "Password" function. Access to configuration mode is free.
- <YES> : activating the function. Need to enter a password to access the configuration mode.
Enter a new code:
PASSWORD?
‘
’
or
‘
’
buttons to change the character. The ‘Config’ button validate the character.
----
(only alphanumeric characters are accepted: '0' to '9' and 'A' to 'Z').
Note
:
When the function is activated by answering YES, a new code is automatically requested.
Note :
The device leaves the configuration mode if no action are made within 60 seconds without saving the modified
parameter. It's only at the end of configuration that new parameters are saved in memory.