Lorell LLR70060, Инструкции, Страница: 2 / 3

INSTRUCTIONS
LLR70060/70061/69140/69145 Wire Shelving Units
1. Assemble posts by taking one short post with threaded stud and inserting into wide threaded hole of
another short post without stud. The narrow threaded hole is where the rubber feet will be inserted at the
bottom of the post. Repeat this step until you have 4 tall posts assembled.
2. Snap shelf supports onto posts by placing two plastic shelf support halves around the posts at the desired
height for the bottom shelf only. Be sure the wider, flared edge of the plastic support is in the down position
toward the floor. The small lip located inside the plastic shelf support must snap into the grooves located at
1” intervals on each post. Repeat this step for each post.
3. Stand one shelf on its side and insert the posts with the plastic shelf supports in place up through the shelf
post holes located at each corner of the shelf until the support meets the shelf. If the plastic shelf support is
snapped together with the wider faired edge down toward the floor, the shelf will lock into place by
tightening itself around the support.
4. Stand the unit upright. Firmly push the bottom shelf onto the shelf supports to stabilize the unit.
5. Add additional shelves by positioning plastic shelf supports at desired heights in the same manner as
described in step B, starting from the bottom up. As you position the shelf supports for each shelf location,
carefully lower a shelf from the top by inserting the four posts into the four holes located at each corner of
the shelf. Work your way up from the bottom to the topmost shelf.