WSDA
®
-200-USB
User Manual
NOTE
Automatic discovery in nodes not included in the LORD Sensing 200 Series will only occur if
the node is set to idle mode. To force boot-up into idle mode, cycle the node power rapidly
two times, and then leave it on. The status indicator on the node will pulse once per second to
indicate it is in idle mode (
see Troubleshooting Guide on page 27
).
If the base and node are on the same operating frequency, the node will populate below the
Base Station listing when powering on the WSDA-200-USB.
Figure 6 - Node Discovered On Same Frequency
If a red circle with a number appears next to the Base Station, the node is operating on a
separate radio channel (
see Move Node To Base Station Frequency on page 14
).
Figure 7 - Node On Other Frequency
11
