lopital Elexo 5100, Инструкция по эксплуатации

Страница: 17 / 28

Elexo Shower-toilet chair | Instructions for use | 17
If the Lopital plastic bedpan, stainless steel bedpan or bucket has been used,
it must be removed from the chair before the chair is moved or adjusted in
height.
3.6. Charging battery
• The Elexo is an electrically driven high / low shower-toilet
chair and works on a battery .
• The charging point is located on the front of the chair, on
the blue cover on the underside of the device (See figure
21).
• If the battery is almost completely empty of charge, the
orange light on the manual control will come on; this
means that the battery needs to be charged .
• If the LED is on continuous red, the battery must be
charged immediately . The chair can then no longer be
used .
• Connect the charger to the Elexo (See figure 21) .
• Once the charger is connected to the Elexo, the controls will go into ‘sleep’ setting
(all functions are switched off) .
Make sure that you push the plug into the correct position in the charging point.
Only the original charger for the Elexo may be used. If you use another charger,
Lopital cannot be held liable for any consequences, such as damage
to the electronics.
Once the charger is connected to the Elexo, the controls will go into ‘sleep’
setting (all functions are switched off).
The charger that must be used for the Elexo is the ‘Mascot 2241’.
• When the indicator light on the charger goes green, the battery is charged .
The charger can remain connected even when the battery is completely charged .
Leaving it connected will not cause any damage .
• Disconnect the Elexo from the charger .
• Once activated, the Elexo is now ready for use
(See paragraph 2.2. Activating) .
Figure 21 Charging point .