www.LoosSeismicBracing.com
Toll Free: 800-321-LOOS (5667)
Ensure that you have read and understand the safety instructions included
in this manual before you operate the tool.
Check whether the tool is damaged. Before using the tool, always carefully
check that parts are functioning correctly.
Check that moving parts do not become stuck and are not damaged.
Do not
use the tool if damaged or defective parts are detected. Damaged
or defective parts must be repaired by a qualified technician.
Slide the battery into the handle until you hear a click.
Before using the tool, check that the moveable piston is in its rest position
(fully retracted, by actuating the retract trigger).
Loos’ battery-driven, handheld, open jaw swaging tool has a powerful
6-ton output which will crimp the 3/32, 1/8, 3/16, and 1/4 inch copper and
aluminum oval sleeves onto the corresponding sizes of wire rope.
The tool utilizes interchangeable dies that are manufactured by Loos & Co.
to fit 3/32, 1/8, 3/16, and 1/4 aluminum and copper oval sleeves. These
dies are sold in pairs, one pair for each size sleeve. The 3/32 and 1/8
sleeves require only one crimp, or one cycle of the tool. The 3/16 sleeves
require two crimps, or two complete cycles of the tool. The 1/4 sleeves
require four crimps, or four complete cycles of the tool.
OPERATING INSTRUCTIONS
Insert Screw
Retract Trigger
Battery
Crimping Jaws
Forward Trigger
4