www.LoosSeismicBracing.com
Toll Free: 800-321-LOOS (5667)
Eye Splice
Lap Splice
TOOL MAINTENANCE AND ADJUSTMENT
CAUTION: Over adjustment will cause the Adjustment Bolt to break.
Your Loos & Co. #3-346SB swaging tool has been designed to give
you years of trouble-free service. To obtain the best possible perfor-
mance, we recommend:
1) Clean and lubricate all moving parts regularly;
2) Keep all bolts tight;
3) Keep your swaging tool properly adjusted using the following
simple procedure:
Each #3-346SB swaging tool is supplied with a gauge. Select the
slot in the gauge corresponding to the sleeve size being com-
pressed. The compressed portion of the sleeve should pass into the
gauge easily. If it does not, then adjust the swaging tool as follows:
With the handles apart, use a 3/16” Allen wrench to tighten the set
screw in the handle ¼ turn. Then compress the sleeve and check
the “after swage” diameter with the gauge. Continue this procedure
until the compressed portion of the sleeve passes easily into the
gauge.
WARNING:
• Wear Safety Googles and Protective Gear.
• Do Not Use on Electrical Circuits.
• Read Instruction Manual Before Use.
4
