10
EN
1 / Check the 2 black liners are in the diagonal tube.
2 / Check the 2 metal end caps are at the TD
entrance towards the head tube. On the left side
a new double cap allows Hydraulic brake liner
A and front derailleur liner B to pass as shown below.
On the right side at C is the mechanical cap for the
rear derailleur cable.
3 / Check that the small black rear cap is at point G
(if not, it is in the accessories bag)
4 / Pass the hydraulic liner from point A to point F,
passing successively through the diagonal tube,
over the bottom bracket and then into the left of
the base and on to the outlet (guide tube without
the frame)
5 / Pass the two derailleur cables through the 2 black
liners. Left hole B rear derailleur. The 2 cables thread
the liners and come out at point F. The front cable will
then come out to join point E. The rear cable will enter
the right rear of the base and come out at point G.
6 / You have the option to fit a front derailleur
tensioner, to do this, cut your front derailleur liner
about 3 cm from the tube exit, then fit the tensioner.
Pass the rear derailleur cable from the shifter and
bring it out behind the bottom bracket.
7 / Check the bottom bracket cable guide is tight.
8 / Finish the assembly with the routing of the fork.
This consists of an upper entry A and a lower one B,
to connect to the front brake caliper.
ROUTING ASSEMBLY
765 DISC HYDRAULIC ROUTING
B
A
C
D
E
F
G
A
B
B
A
B
A
