Look Solutions Viper NT, Руководство по эксплуатации

Страница: 10 / 21

9
5. Operating the Viper nt
The Viper nt is a powerful fog generator, producing every desired effect from a tiny
puff of smoke to the thickest fog.
Digital technology makes fine adjustments of the pump possible. In steps of 1% the
output can be adjusted from 1-99%.
5.2 Putting into operation
a. Connect the Viper nt to the mains supply. Make sure the correct voltage is selected
(230 V/50 Hz). A „P” and two figures appear on the display.
b. After a warm up time of approx. seven minutes the Viper nt is ready to start. The
green Ready-Led [22] blinks if the working temperature is reached. As soon as the
final temperature is reached, the LED illumates permanently.
c. Adjust the required output via the control panel and press the Enter-button [18]
once to start the fogging process (see point 5.4).
5.3 Switching the device off
a. Press the Mode-button [16] til „OFF” appears on the display. After 15 seconds the
machine will switch off automatically. On the right bottom edge of the display a red
decimal point appear.
You can also switch off the machine within these 15 seconds by pressing the Enter-
button [18].
b. When you switch off the DMX signal, the machine will be switched off automatically
after 15 seconds.
P 2 5
.