Look Solutions Radio remote V.5, Руководство по эксплуатации

Страница: 9 / 16

9
4.2 Activating the transmitter buttons
The machine connected to the receiver will be operated by pressing an activated
button on a paired transmitter, creating fog as long as the button is held down.
Activate transmitter buttons by using jumpers [3] inside the receiver. The receiver is
delivered with one jumper active in position 1 and 2 jumpers in an inactive (stored)
position.
Figure 1 shows a receiver with jumper active in „Button 1“, and in storage (inactive)
position on „Button 4“ and „Freq. 2“. This receiver will respond to Button 1 on any
transmitter that has paired with it.
Figure 2 shows a receiver with jumper active on „Button 3“, and in storage (inactive)
position on „Button 4“ and „Freq. 2“. This receiver will respond to transmitter Button
3.
4. Configuring the Radio Remote
To place or move jumpers [3]:
a) Open the receiver by removing the two screws on the side where the antenna is
installed. Pull the PCB out of the housing.
b) Connect the receiver to the machine.
c) To activate a button, place the jumper so that it covers both pins. If there is no jumper,
or a jumper on one pin only, then that button is not active.
You can have several buttons active simultaneously. For example, if you place four
jumpers in the active position for all four buttons, then any button on the transmitter
will activate that receiver.
Figure 3 (see next page) shows a receiver that will respond to either button 2 and
4.
You can activate several receivers on the same button, and then all receivers will be
operated when the button is held down, simultaneously and for the same duration, pro-
vided of course that all receivers have previously been paired with that transmitter.
If you wish the receivers to be operated independently rather than simultaneously,
then activate a different button on each receiver.
Please note that moving jumpers to activate or de-activate buttons does not require
re-pairing of the transmitter and receiver.