134
When tire pressure is inspected and adjusted, it should be carried out after the tire is fully
cooled.
Pressure of Nitrogen inflated tire is the same as that of the air-inflated tire.
5.13 MAINTENANCE FOR LONG TIME PARKING
If the machine will be stored for a long time exceeding one month, the following steps
should be followed with:
1. The machine should be stored in dry room. If the car has to be parked in the open air,
it should be stopped on the concrete ground for easy drainage of water, and cover it
with canvas.
2. Before store the car for a long time, please completely clean each part of the car, do
not leave any dirt or mud on the surface and air it dry.
3. Put the bucket down level on the ground, set the gear shifting joystick at neutral
position. Rotate the button of the parking brake to reset it, push the negative switch to
the off position, and lock the door of the cab.
4. Fill diesel full into fuel tank, fill lubricating grease over the pins and shafts, and smear
a layer of engine oil over the exposure part of the piston rod of the hydraulic cylinder.
5. Dismount the battery and store it separately.
6. If the temperature drops down to below 0
℃
, add anti-freeze fluid into the engine
cooling system, and to fill the anti-freeze fluid to reach to the engine body and the
evaporator of the air conditioner system.
7. Drain out the water in the cooling system, please note to drain out the water in the
evaporator of the air condition system.
8. Start the car once a month, to run each system, and fill lubricating grease over all
moving pins and shafts, to ensure all moving parts to be lubricated. Before star the
engine, remove the engine oil over the piston rod.
5.14 MAINTENANCE UNDER SPECIAL CONDITIONS
Maintenance for the operation in mud, water or rain
Inspect the connections around the car to confirm whether there are loose joints, machine damage or
leakage.
After operation is completed, clean the mud, rocks, gravel, etc. left on the machine; inspect the
welding seam to confirm whether there are cracks and whether there is loose; carry out daily
lubrication and maintenance.
If the car is working in acid rain or corrosive media, please flush to clean the affected parts with clean
water rinse.
