ForceCut™ Series Plasma Cutters
www.longevity-inc.com
13
7
torch’s ON/OFF switch can be positioned on the top, the side, or the bottom of the
torch body for most of the torches.
Assembly of Consumables for the LP-40D/50D/60/70/80/100
Assemble the consumables as pictured above, and described below.
1.
Insert the electrode.
2.
Seat the ring on the electrode. Please note not all torches use a swirl ring –
the 60amp and 100amp torches do not have a ring.
3.
Place the copper tip on the ring, ensuring that is seated flat.
4.
Secure all parts into place by turning the ceramic cup clockwise until it is
snug. Do not over tighten.
The torch consumables are now successfully assembled.
Assembly of Consumables for the LP-60D/100
Assemble the consumables as pictured above, and described below.
1.
Insert the electrode.
2.
Place the copper tip on the ring, ensuring that is seated flat.
3.
Secure all parts into place by turning the pink ceramic cup clockwise until it
is snug. Do not over tighten.
The torch consumables are now successfully assembled.
Assembly of Consumables for the LP-70/80/100
This assembly is similar to the cutters described above, except it does not use a ring.
1.
Insert the electrode, and tighten with special electrode wrench until snug.
2.
Place the copper tip on the electrode, ensuring that is seated flat, and tighten
with wrench until snug.
3.
Secure all parts into place by turning the ceramic cup clockwise until it is
snug. Do not over tighten.
The torch consumables are now successfully assembled.
Operation
1.
Ensure that all cables are connected to the machine.
2.
Ensure that the machine’s OFF/ON switch is set to OFF, and plug the machine
into the electrical outlet.
3.
Connect the air compressor supply line to the input side of the air regulator/filter.
4.
Turn the ON/OFF switch to ON. The cooling fans should operate and the ON
indicator LED (if applicable) should illuminate. Your amps should be shown on
the digital display and are adjustable with the knob.