Guest Alpha Coasters
This procedure is repeated for each pager being programmed. Two charging bases are suggested for pro-
gramming Alpha Coasters.
Note:
Programming Guest Alpha Pagers requires an authorization code (which must be obtained
from LRS).
1. Put all coasters to be programmed on one charger base, leave the second base empty
2. Complete the steps for programming “Invidual Pagers” (see pg. 24)
3. At the Select Type menu, press 1 (1: Guest Pagers)
4. Enter the programming authorization code obtained from LRS (once received this step will no
longer be required)
5. Select 1 (1: Coaster)
6. Select 2 (2: Alpha)
7. At Enter ID --- enter the number you wish to assign to the pager and press ENTER
8. At All Page --- enter the All Call number for the pager to be programmed and press ENTER
10. Remove the coaster from the charger
11. When flashing stops, press ENTER
12. The pager will beep four times to indicate it is being programmed and the screen will display:
Example:
System ID = 0, Pager ID Number = 99, All Page = 911
• [0]123 prg Single
• [0]911 prg All Page
• [0]0 prg System
• prg encryption none (alt 128 key) (See Alpha Encryption – pg. 29)
13. Repeat steps 2 through 12 for the remaining coasters.
14. When finished, remove all of the coasters from the charging base and page each one
15. Reprogram any that do not page.
16. When finished, press F1 (EXIT)
Staff Pagers (Star Type)
This procedure is repeated for each pager being programmed. Pagers may be replaced into the same slot in
the charger.
1. Place all pagers to be programmed in the charger.
2. Complete the steps for programming “Invidual Pagers” (see pg. 24)
3. At the Select Type menu, press 2 (2: Staff.)
4. Enter the programming authorization code: 1-2-3-7-6
5. Select 1 (1: Star Pager)
6. At Enter ID --- enter the number you wish to assign to the pager and press ENTER
7. Remove the pager from the charger
8. When the flashing stops, press ENTER
9. The pager will slowly brighten and dim to off to indicate it is being programmed
10. When programming is finished, return the pager to its charging base
11. Repeat steps 1 through 9 for the remaining pagers
12. When finished, remove all of the pagers from the charging base and page each one
13. Reprogram any that do not page.
14. When finished, press F1 (EXIT)
Long Range Systems
25
T7400 User Manual