When activated:
• A signal is sent out to ALL coaster/ pagers.
• Pagers will Beep or Flash until returned to charging unit or batteries removed (pager).
To activate:
1. Press SETUP
2. Press F1 (MORE) until asked for authorization code
3. Enter Authorization Code: 5-6-7-8-9
4. Press 1 (1: Prg Auto Func.)
5. Choose 1 (1:Prgm Auto Loc.) to program auto locate
6. Press F1 (ON) to turn Auto-Locate mode on or press
F2 (OFF) to turn off
7. Press F4 (DONE) to exit or F3 (HELP) for help
If turning function ON:
8. Enter Start Time for Auto Location (- -: - -) and
press ENTER to continue
9. Press F1 (AM) or F4 (PM)
Run Locate
Run locate is used to immediately locate any misplaced coasters around the restaurants (ideal during clos-
ing hours).
When activated:
• A signal is sent out to ALL guest pagers.
• Pagers will Beep or Flash until returned to charging unit or batteries removed.
To activate
1. Press SETUP
2. Press F1 (MORE) until asked for authorization code
3. Enter Authorization Code: 5-6-7-8-9
4. Press F1 (MORE) until display shows 3: Run LOCATE
5. Press 3 (Run LOCATE)
6. Select F3 (MODE)
8. Press F1 (Go) to start locating
Tracking Modes
There are 2 tracking modes:
•
Continuous Tracking – repeatedly sends paging signals until cleared.
•
Custom Tracking – sends paging signals for a specified length of time, based on a user-defined time
interval.
Continuous Tracking
This function allows the host to set paging to occur continuously, and monitor which Guest or Staff pager
has been paged. Paging continues until the number is cleared on the keypad unit.
Long Range Systems
12
T7400 User Manual
