London Electronics EasyReader ER4P, Инструкция по эксплуатации, Страница: 7 / 20

Getting Started
First, check that the display will suit your application and the available power source (either 95-265
VAC or 11-30 VDC).
If you asked us to configure the display for you, please check that the scaling and settings agree
with your requirements.
We fully tested and calibrated your display for you, but a pre-installation test may be useful to check
that everything works as needed.
Remove the screws which hold the rear panel in place.
Feed the signal and power cables through the cable glands.
Connect the signal and power cables to the appropriate screw terminal connectors. See our
connection drawing to check that you are using the correct terminals.
Check, before switching on, that the power is suitable for the unit.
Switch on, and the display should show ‘EPX.X’ for a second or two. (where EPX.X is the software
version). Units with custom software will have a different prompt.
Next, ‘C. XX’ will appear for a second or two. The XX value increases each time a calibration is
completed. The display should then show a steady reading relating to zero input signal; for the
factory default 4-20mA scaling, this should be between -24.9 and -25.1.
4